![]() The type of bulb your Subaru requires depends on many factors, such as driving conditions and what year/trim level it is. Once the bulbs are securely fastened and all proper equipment is reconnected, turn on the headlights to ensure they are in good working order and that all systems are functioning properly.This can prevent excess corrosion which can cause the battery to wear out prematurely If you had to remove the battery before accessing the bulbs, be sure to give the base where the battery was located a good cleaning with a rag, as well as the connectors for the positive and negative adapters, using a clean cloth.Gently place all tubing back in their original spots and reconnect the rivets by pushing them in, then screwing them back in securely. ![]() After the bulb is replaced, push the bulb connector back into its original position, linking the pin back to where it was and turning the plastic cover back in clockwise to refasten it.Discard the bulb and use a gloved hand to push the new one in where the old one was, using a gloved hand.If the bulb is kept in this system, there will be a small tab button on the side of the connector, which you can press to release the bulb by pulling it out.Some Subaru models, such as recent Crosstrek models, do not have the plastic cover, but you can simply find their bulb cover in the same position and twist it counterclockwise to remove it as you would with the plastic cover.Behind the plastic cover, there will be a pin keeping the bulb in place push it in and it will swing out, allowing you to pull the bulb itself out. Typically, the bulb is housed behind a plastic cover, which can simply be unscrewed by turning the plastic mold counterclockwise and removing.Then, unscrew the main bracket and use the attached handle to lift the battery our when everything is unscrewed. If this is the case, use a 10-millimeter wrench to unscrew the negative charge first, then the positive. For models like the Subaru Impreza, the battery itself may be blocking the bulb housing.With the coolant tube, keep in mind that there may be some excess coolant that may leak out, so have a towel at the ready to soak up the excesses. Once the rivets are unscrewed, you may remove the necessary tubes.Use a panel popper to remove the rivets and set them aside in a place where you can find them easily. To remove these, use the screwdriver to gently unscrew the rivets while applying pressure to the outside. Typically, one side will be blocked by the windshield washer fluid intake tube, while the other will be blocked by a cover or the air intake snorkel tube. ![]()
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |